Ano-Tech Computers
Enter keyword:

How to recover from a "broken" Zyxel firmware
Problem:
Router won't boot properly, it's impossible to access the system menu and perform a firmware upgrade.
 
Solution:
First, retrieve the correct firmware .bin file from zyxel.com. The router will accept any file you upload to it, so make sure you get the correct version.

Using a 9-pin console cable and hyperterminal, minicom or a similar terminal emulator, power-cycle the router and enter debug mode by pressing any key within 3 seconds of power-on.

1. Type "atur" and hit Enter
2. Wait for the "Starting XMODEM upload" prompt
3. Transfer the .bin file using the X-modem protocol
4. Type "atgo" to boot the new firmware





 
Discuss this solution
Did this article solve your problem? Yes No Did not apply

This is free technical advice without any warranties. Use at your own risk. Solutions offered may not apply to your particular problem at all. Opinions and views expressed in the articles are the authors' personal and may not necessarily reflect or coincide with those of Ano-Tech Computers. We take no responsibility if anything bad happens from following any of the intructions given. If you don't understand and accept this, please contact us for personal assistance instead.
To read our full disclaimer, go here.

We welcome anyone who is willing to contribute to this public knowledge base, contact siteadmin@atc.no if you have information you would like to share. The idea is not to replace the commercial support sites, but to publish those hard-to-find solutions you've found yourself looking for over and over again.

Show all articles