Ano-Tech Computers
Enter keyword:

Samba stopped working after being upgraded
Problem:
Newer versions of Samba refuses to let users log on, using the same smb.conf that used to work before.
 
Solution:
From the Samba FAQ: http://us1.samba.org/samba/docs/FAQ/#4

> Unknown parameter encountered: "domain controller"
> Ignoring unknown parameter "domain controller"

As of 1.9.18 the "domain controller" parameter has changed. You should
not need it, but in it's place may need "networkstation user logon = yes".
Please check the smb.conf man page BEFORE using this option so you
understand it's significance.


 
Discuss this solution
Did this article solve your problem? Yes No Did not apply

This is free technical advice without any warranties. Use at your own risk. Solutions offered may not apply to your particular problem at all. Opinions and views expressed in the articles are the authors' personal and may not necessarily reflect or coincide with those of Ano-Tech Computers. We take no responsibility if anything bad happens from following any of the intructions given. If you don't understand and accept this, please contact us for personal assistance instead.
To read our full disclaimer, go here.

We welcome anyone who is willing to contribute to this public knowledge base, contact siteadmin@atc.no if you have information you would like to share. The idea is not to replace the commercial support sites, but to publish those hard-to-find solutions you've found yourself looking for over and over again.

Show all articles