Ano-Tech Computers
Enter keyword:

D-Link DAP-1353: Reset and reconfigure
Problem:
I pressed the reset button, but still can't find anything at 192.168.0.1
 
Solution:
Power off the unit, hold the reset button and power on. Release the reset button after 10 seconds.

The unit is now reset to default configuration:
AP Client mode
LAN IP 192.168.0.50
User name "admin"
Password "" (blank)
 
Discuss this solution
Did this article solve your problem? Yes No Did not apply

This is free technical advice without any warranties. Use at your own risk. Solutions offered may not apply to your particular problem at all. Opinions and views expressed in the articles are the authors' personal and may not necessarily reflect or coincide with those of Ano-Tech Computers. We take no responsibility if anything bad happens from following any of the intructions given. If you don't understand and accept this, please contact us for personal assistance instead.
To read our full disclaimer, go here.

We welcome anyone who is willing to contribute to this public knowledge base, contact siteadmin@atc.no if you have information you would like to share. The idea is not to replace the commercial support sites, but to publish those hard-to-find solutions you've found yourself looking for over and over again.

Show all articles