|
|
|
|
| Configuring a USR Courier v.everything for leased-line operation |
|---|
|
Problem:
This article solves several problems related to leased-line operation. The solutions provided may only apply to certain models.
In particular, this article solves the problem where two modems seem to communicate just fine when using a terminal emulator but ppp negotiation fails completely due to garbled frames.
|
|
Solution:
First of all, here is the init-string: AT&B1&S1&H1&L1&W
If your cables/serial ports/whatever does not support hardware flow control, replace H1 with H2 and change your software configuration accordingly.
Remember that all serial communication between PC compatibles at rates above 19200 baud require UART 16550A chips, the 16450 has a smaaler FIFO buffer and will overrun.
Client DIP settings: 1001000000 (1 = On/Down, 0 = Off/Up)
Server DIP settings: 1001100000 (1 = On/Down, 0 = Off/Up)
To change init-strings you need to power off, set switch 8 ON, power on, type the AT commands as necessary, then turn the modem off, reset switch 8 to OFF and power back on.
|
|
|
|
|
|
This is free technical advice without any warranties.
Use at your own risk. Solutions offered may not apply to your particular problem at all.
Opinions and views expressed in the articles are the authors' personal
and may not necessarily reflect or coincide with those of Ano-Tech Computers.
We take no responsibility if anything bad happens from following any of
the intructions given. If you don't understand and accept this, please
contact us for personal assistance instead.
To read our full disclaimer, go
here.
We welcome anyone who is willing to contribute to this public knowledge base,
contact siteadmin@atc.no
if you have information you would like to share. The idea is not to replace
the commercial support sites, but to publish those hard-to-find
solutions you've found yourself looking for over and over again.
Show all articles
